The MADS tuning software is well known as CaTCHER software
MADS original products were EPROMs and Flash-EPROMs (or “chips”) which could be installed in place of the original OEM EPROMs and Flash-EPROMs located in the vehicle’s on-board control module. These chips, just like the tuners of today, keep the entire vehicle safety and emissions systems intact, but modify the fuel injection settings to deliver dramatic power, torque and driveability improvements.
Also the fuel consumption is one of the most important point of MADS company research. CaTCHER softwares can be used to reduce fuel consumption up to 15% depending on the driving condition. Saving money and reducing the vehicle emissions.
With the advent of OBD-II vehicle control module in the early 1990’s, most domestic vehicle manufacturers installed under-dash ports (“ALDL ports”) which allowed dealers and service techs to “re-flash” the vehicle's control module to change engine settings without replacing any chip.
So today, instead of chips, MADS company primarily sells hand-held tuners which achieve the same dramatic drivetrain improvements, without the hassle of popping the hood, pulling out the vehicle control module and replacing a chip. Installation is quick and easy, taking about 1.5 up to 4.5 minutes, depending on the truck model, and requiring no tools or mechanical skills whatsoever.
MADS Company has three main concerns :
1) Product quality
2) Customer satisfaction
3) Customer Service
